KSEB Three Phase Connection Charges |Single Phase to Three Phase Conversion|KSEB

If your existing  connected load is greater than 5kw, 3 phase conversion is a must. 

Let us see the step by step procedure of KSEB  Single Phase  to Three Phase Conversion.

First  of all, the wiring should altered  for a 3 phase  service  connection. In this regard a 3 phase  DB(Distribution Box) is needed. 

After completion  you need to apply for this along with the following documents. 

1.Application  Form (For load Change )

2.Identity  Proof

3.Test report/Completion  Certificate from a licensed electrical  contractor. 

4.Sketch  showing the connected  equipments.

5.General  Test Report (for office use )

In this time, Application fee of ₹89 has to be remitted.

After field  verification, You will get a demand  note  including CD(Cash Deposit ) ECSC  (Estimate  Cost  for  Service  Connection ).

Normally CD is ₹300 per kw for a domestic connection(₹1000 for most  of the other  purposes ).You have to pay only  the additional amount required as CD.

Suppose, your  new load is 8750 watts  and your existing CD (otherwise  called Security  Deposit )is ₹2100.So you have to pay ₹600 only.

ECSC is as follows :-

1.Below  10 kW

₹4170+₹375(CGST )+₹375(SGST )=₹4920

2.Above 10 kW and below 25 kw 

₹15450+₹1391(CGST )+₹1391(SGST )=₹18231

If you need  OH line  Construction  or conversion the  basic  rates  as follows. GST(18%)  extra. 

1.Construction  of L T 3 Phase  4 wire  line-₹460/meter. 

2.Conversion  of LT Single  Phase  2 wire  line to LT 3 Phase  4wire  line-₹165/meter. 

After  fee remittance, your  5-30 Ameter is replaced by a10-60A meter. This should not  change your  consumer number, change only  your phase.